Venetian gold granite – Installing a Venetian gold granite countertop vanity adds the elegance of natural stone vanity base and provides an easy to clean surface that difficult to damage. With the addition of a vanity sink it becomes much more useful. The pre-cut Venetian gold granite countertop sink facilitates installation, allowing you to connect the sink to the counter and countertop vanity often in less than an hour.
Place the pre-cut Venetian gold granite countertop upside down on the basis of vanity. Wrap the threads of the water connector’s faucet with Teflon pipe tape to help prevent water leakage. Place the tape around the wires that go to the left for about four laps around the connector. Or ring faucet during connecting hoses and above the faucet base. Push the connectors through the whole tap on the counter and press the faucet base through the hole until faucet is flush with the counter top. Pumping a bead of silicone caulk on the bottom of the countertop around the cut opening for the sink using a caulking gun. Install the mounting hardware to hold the sink in place with epoxy adhesive.
Place the pin on the clip and the stem, and then screw in place with a wrench until tight. Lift the cover. Use a helper if the top with sink is too heavy to lift alone. Flip the counter again and then place on the basis of vanity, right side up. Tilt the top up to the front and place a layer of putty on the edge of the vanity along the top of the cabinet. Lower the Venetian gold granite countertop vanity again, the use of silicone caulk as an adhesive. Allow the putty to dry for 24 hours.